Important Safety Information - CONSTRUCTA CD639860 Gebrauchs- Und Montageanleitung

: Important safety information

Read these instructions carefully. Only then
will you be able to operate your appliance
safely and correctly. Retain the instruction
manual and installation instructions for
future use or for subsequent owners.
Check the appliance for damage after
unpacking it. Do not connect the appliance
if it has been damaged in transport.
The appliance can only be used safely if it
is correctly installed according to the safety
instructions. The installer is responsible for
ensuring that the appliance works perfectly
at its installation location.
The surfaces of the appliance are easily
damaged. Avoid damaging them during
installation.
The width of the extractor hood must
correspond at least with the width of the
hob.
For the installation, observe the currently
valid building regulations and the
regulations of the local electricity and gas
suppliers.
This appliance is installed on the wall.
■
Follow the enclosed installation instructions for additional
■
special accessories (e.g. for circulating-air mode).
The surfaces of the appliance are sensitive. Avoid damaging
■
them during installation.
I m p o r t a n t s a f e t y i n f o r m a t i o n
Risk of fire!
Fatty deposits in the grease filter may
■
catch fire. The specified safety clearances
must be complied with in order to prevent
a build-up of heat. Refer to the information
provided for your cooker. If gas and
electric hobs are being operated together,
the largest specified clearance applies.
Grease deposits in the grease filter may
Risk of fire!
■
catch fire. Never work with naked flames
close to the appliance (e.g. flambéing). Do
not install the appliance near a heat-
producing appliance for solid fuel (e.g.
wood or coal) unless a closed, non-
removable cover is available. There must
be no flying sparks.
When conveying the exhaust air, official and
legal regulations (e.g. state building
regulations) must be followed.
Risk of death!
Risk of poisoning from flue gases that are
drawn back in. The exhaust air must not be
conveyed into a functioning smoke or
exhaust gas flue or into a shaft which is
used to ventilate installation rooms that
contain heating appliances. If the exhaust
air is to be conveyed into a non-functioning
smoke or exhaust gas flue, you must obtain
the consent of the heating engineer
responsible.
23