Risk Of Injury; Risk Of Electric Shock; Environmental Protection; Environmentally-Friendly Disposal - CONSTRUCTA CD639860 Gebrauchs- Und Montageanleitung

Risk of injury!

Components inside the appliance may
■
have sharp edges. Wear protective gloves.
Items placed on the appliance may fall
Risk of injury!
■
down. Do not place any objects on the
appliance.
The light emitted by LED lights is very
Risk of injury!
■
dazzling, and can damage the eyes (risk
group 1). Do not look directly into the
switched on LED lights for longer than
100 seconds.

Risk of electric shock!

A defective appliance may cause electric
■
shock. Never switch on a defective
appliance. Unplug the appliance from the
mains or switch off the circuit breaker in
the fuse box. Contact the after-sales
service.
Incorrect repairs are dangerous. Repairs
Risk of electric shock!
■
may only be carried out and damaged
power cables replaced by one of our
trained after-sales technicians. If the
appliance is defective, unplug the
appliance from the mains or switch off the
circuit breaker in the fuse box. Contact the
after-sales service.
Do not use any high-pressure cleaners or
Risk of electric shock!
■
steam cleaners, which can result in an
electric shock.

Environmental protection

Your new appliance is particularly energy-efficient. Here you
can find tips on how to save even more energy when using the
appliance, and how to dispose of your appliance properly.
Saving energy
During cooking, ensure that there is a sufficient supply of air
■
so that the extractor hood can work efficiently and with a low
level of operating noise.
Adjust the fan speed to the intensity of the cooking fumes.
■
Only use intensive mode where this is required. A lower fan
speed means that less energy is consumed.
If there are intensive cooking fumes, select a higher fan
■
speed in good time. If cooking fumes have already spread in
the kitchen, the extractor hood must be operated for longer.
Switch off the extractor hood if you no longer require it.
■
Switch off the lighting if you no longer require it.
■
Clean and, if required, replace the filter at regular intervals in
■
order to increase the effectiveness of the ventilation system
and to prevent the risk of fire.
Causes of damage
Caution!
Risk of damage due to corrosion. Always switch on the
appliance while cooking to avoid condensation. Condensate
can produce corrosion damage.
Always replace faulty bulbs to prevent the remaining bulbs from
overloading.
Risk of damage due to ingress of humidity into the electronic
circuitry. Never clean operator controls with a wet cloth.
Surface damage due to incorrect cleaning. Clean stainless
steel surfaces in the direction of the grain only. Do not use any
stainless steel cleaners for operator controls.
Surface damage due to strong or abrasive cleaning agents.
Never use strong and abrasive cleaning agents.
Risk of damage from returning condensate. Install the exhaust
duct in such a way that it falls away from the appliance slightly
(1° slope).
Risk of damage as a result of incorrect loading of design
elements. Do not pull design elements.Do not place objects on
the design elements or hang objects from them.
Caution!
There is a risk of surface damage if you do not peel off the
protective film.Remove the protective film from all parts of the
appliance before using the appliance for the first time.
E n v i r o n m e n t a l p r o t e c t i o n

Environmentally-friendly disposal

Dispose of packaging in an environmentally-friendly manner.
This appliance is labelled in accordance with
European Directive 2012/19/EU concerning used
electrical and electronic appliances (waste electrical
and electronic equipment - WEEE). The guideline
determines the framework for the return and recycling
of used appliances as applicable throughout the EU.
17