Replacing The Batteries; Weather Station; Sensors - Conrad TE827NL Bedienungsanleitung

13. Replacing the batteries

a) Weather station
A battery exchange is required once the display contrast becomes very weak or if the symbol "
display field for the time.

During the battery change, all settings and all saved data (e.g., air pressure progress during the past
24 hours, min/max values, etc.) are lost.
If an external power unit is connected while the batteries are replaced (not included in the delivery,
available as an accessory), this data remains saved.
b) Sensors
The symbol " " also appears for each sensor (temperature/air humidity sensor, rain sensor, wind sensor) in the
respective display section if the sensor's batteries are spent.
Exchange the batteries of the sensor for new ones. Proceed as described in the chapter "Commissioning" to
exchange and insert the batteries.

If the weather station can no longer identify the sensor (e.g. if the display still shows "- - - - -" for the wind
sensor one hour after changing the batteries), perform a manual search for the sensors.
For this purpose, keep the button " " (6) depressed until the symbol for the radio reception of the
outdoor sensors blinks on the top of the display. The sensor search may take a few minutes.
When exchanging the batteries of the wind sensor, please note that the tip of the weathercock is aligned directly north
when inserting the new batteries. Afterwards, press the button "SET" (30) located on the side inside the wind sensor's
battery compartment (see arrow in the image on the right). Otherwise the weather station will indicate the wrong wind
directions!
All manuals and user guides at all-guides.com
" appears in the
83