Use; Lighting The Burners; Hob Cleaning And Maintenance - Franke FHPL 301 1GA XS C Gebrauchs- Und Installationsanleitung

Use

Lighting the burners

The control knobs on these models incorporate the ignition and safety device. To light the
burners, proceed as follows:
1. Turn the required knob.
2. Keep the knob pressed down for 3-4 seconds to allow the sparks to ignite the gas as it
comes out the flame-spreader and to allow the thermocouple to heat up.
3. After 3-4 seconds, release the knob and turn it anti-clockwise to adjust the flame to the
required setting. If the flame goes out, repeat the operation from step 1.
Burner use
For better efficiency and lower gas consumption, use pots of suitable width for the
burners, making sure the flame does not extend beyond the edges (respect the table).
Automatic safety valve
This safety device automatically closes the gas cock in the event one of the burners goes
out accidentally as a result of draughts, a pot spilling over, or a temporary interruption of
the gas supply. This device intervenes approximately 30 seconds after the flame has gone
out.

Hob cleaning and maintenance

Before carrying out any hob cleaning or maintenance, always unplug the appliance or
disconnect the power by means of the main switch.
• Stainless steel and enamelled parts will remain pristine if regularly cleaned with water
or using specific products, and thoroughly drying them afterwards.
• To restore the original lustre, periodically use Franke's special stainless-steel cleaner
and microfibre cloth, available from your retailer or the Franke After-sales Service.
• NEVER use scouring pads, steel wool, muriatic acid or other products which could
scratch or mark the surface. Do not use steam cleaners.
• Do not leave acid or alkaline substances or rusty iron items on the hob.
• Remove as soon as possible any food residuals deposited during cooking.
• The burners and flame-spreaders can be removed from the hob and cleaned with hot
soapy water (DO NOT place in dishwasher); dry thoroughly after cleaning. Make sure the
gas outlet zones are perfectly clean.
• The natural colour of the pot grids, in the pot placing section, may alter over time as a
result of heat. To clean the pot grids, proceed as with the burners.
12
All manuals and user guides at all-guides.com
Symbols
Circle
large flame
small flame
: cock closed;
: maximum gas delivery;
: minimum gas delivery.