Panasonic ER-GB40 Bedienungsanleitung Seite 4

Charge
Charging the trimmer
Perform the following steps to charge the trimmer if it seems to
lose the speed.
1
1
Turn off the trimmer and insert
it in the AC adaptor until it
clicks as illustrated.
• The trimmer will not charge unless the
side terminals are in contact with the
charging terminals.
• Wipe off any water droplets on the side
terminals.
• If you charge the trimmer with power
switch turned on, it will start working when
you remove from the AC adaptor.
2
2
Put the plug into a household outlet.
The charge indicator lamp glows red.
• Charging time differs depending on the rated voltage.
(See page 9.)
• When charging the trimmer for the first time or when it has not
been in use for more than 6 months, the charge indicator lamp
may not glow for a few minutes, or the operating time may
shorten. Please charge it for more than 18 hours in such cases.
3
3
Disconnect the plug after charging is
completed.
• To keep charging the battery will not affect battery performance.
• Recommended ambient temperature for charging is 0 ‑ 35 °C.
The battery may not charge properly or not at all under extreme
low or high temperatures.
• The charge indicator lamp glows and stays on until the plug is
disconnected from a household outlet.
4
ER-GB40_EU.indb 4
• A full charge supplies enough power for approximately
50 minutes of use.
You cannot operate the trimmer while charging.
Use
Using the comb attachment
Make sure that the trimmer is turned off.
2
1
1
Turn the dial to the "1" position.
1
2
2
Mount the comb attachment to the
main body until it clicks.
3
3
Turn the dial to move the comb attachment to
the desired trimming length (between 1 mm
and 10 mm).
Trimming length (mm)
(estimate)
Indicator
Trimming length (mm)
(estimate)
Indicator
• Actual hair length will be a little longer than the height you set.
1 1.5 2 2.5 3 3.5 4 4.5 5 5.5
1 1.5 2 2.5 3 3.5 4 4.5 5 5.5
6 6.5 7 7.5 8 8.5 9 9.5 10
6 6.5 7 7.5 8 8.5 9 9.5 10
2012/06/14 13:21:06