Operation; Ready For Use; Receiving Calls; Making Calls - AUDIOLINE DECT 3000micro Bedienungsanleitung

AUDIOLINE DECT 3000micro

3. OPERATION

3.1

READY FOR USE

Under normal operating conditions, the handset display shows the message
MULTI 1. You can change this display at any time and enter a different name. For
more information, see Chapter 7.8.
3.2

RECEIVING CALLS

When a call comes in, the ringing tone sounds on the handset and also on the
base station. The message EXT flashes in the display. Due to the radio
transmission, the handset rings a little later than the base station. Wait until you
hear the ringing tone on the handset in order to accept the call.
To accept the call, press the
To end the call, replace the handset on the base station or press the
button on the handset.
Note: Calls are accepted directly as soon as you lift the receiver from
the base station. It is not necessary to press the call button on the
handset.
3.3

MAKING CALLS

Enter the required telephone number using the keypad. The numbers
pressed are shown in the display. A maximum of 12 digits can be shown in
the display. For longer telephone numbers, only the last 12 digits will be seen
in each case. If you have entered a number incorrectly, you can delete the
individual numbers by briefly and repeatedly pressing the
press the
at once.
Press the call button
To end the call, replace the handset on the base station or press the
button on the handset.
You can also get a dialling tone by first pressing the call button
entering the digits of your required telephone number, your AUDIOLINE DECT
3000micro dials the number directly. With this method of making a call, it is not
possible to correct individual digits in the number in the manner described above.
button for longer, the whole telephone number will be deleted
and the required connection will be made.
button.
OPERATION
button. If you
. On
53