6
T-NET mode / Private exchanges
You can use the "R" signal button on your telephone on private exchanges and when
using DEUTSCHE TELEKOM's T-Net functions.
6.1
"R" Button on private exchanges
If you have connected your telephone to a private exchange, you can use all the facilities
such as call transfer, automatic recall, etc. The "R" signal button gives you access to
these facilities. The FLASH time "100ms" will normally be required on a private
exchange. (For adjusting, see 7.2). You can find out from the dealer from whom the
equipment was purchased whether your telephone will work on your private exchange
without any problems.
6.2
"R" Button and the DEUTSCHE TELEKOM T-Net
Your AUDIOLINE telephone supports the most important DEUTSCHE TELEKOM added
value functions (e.g. brokering, call waiting, three-way conference, etc.). The T-Net
works using the "FLASH 300ms" setting. (Adjustment, see 7.2). Please contact
DEUTSCHE TELEKOM to gain access to T-Net functions.
6.3
Using Pause
With private exchanges, it is necessary to dial a certain number (e.g. "9" or "0") in order
to obtain a dialling tone for an outside line on the extension. With some, older private
exchanges, it takes some time before the dialling tone can be heard. Especially for these
private exchanges, an automatic pause can be inserted after connecting to the outside
line so that you can dial directly without waiting for the dialling tone.
Entering a pause when dialling manually
Press and hold the # P button between the number for the outside line and the actual
telephone number until the P symbol appears in the display and then continue entering
the phone number.
After connecting to an outside line your telephone will wait for 3 seconds before dialling
the actual telephone number.
The pause can also be saved with numbers in the phone book.
- T-NET/Private exchanges -
35