eta 7149-30 Bedienungsanleitung Seite 37

7) TIME button
This button is used to set the required bread completion time. Max. bread completion time
can be set to 15 hours (this includes the time of the selected programme). The display
will show the total bread completion time. Delayed start cannot be set for the following
programmes: 6-KNEADING, 7-CAKE, 8-BAKING, 9-JAM, 10-YOGHURT, 11-BUGUETTE,
BUNS, 14-MUFFINS, 15-BUGUETTE, BUNS.
The Time buttons are also used to set the programme time for the following programmes:
7-KNEADING, 8-BAKING, 10-YOGHURT and and to set the time of the individual
– Only use the timer with recipes you have tried with successful results, and do not
change the recipes any further.
– Yeast cannot come into contact with water before the programme is started.
– Excessive dough could spill over and get stuck to the heating element.
– When using the timer, never use perishable ingredients, such as fresh milk, eggs, fruit,
yoghurt, cheese, onion, etc. as they could go bad over night!
– Use the bread maker only in rooms with a temperature over 18 °C. Yeast starts
working at a temperature of approx. 17 °C or more. If the bread maker is used in
a colder room, the dough may not prove well.
– The add-ingredients signal sound (for adding nuts, seeds, dried fruit, etc.) and
end-of-programme signal sound cannot be switched off and they will sound at night as well.
Signal sounds
The signal sounds will be activated:
• when any of the programme buttons is pressed,
• during the second kneading cycle with the following programmes: 1-CLASSIC,
2-FAST, 3-SWEET, 4-WHOLEGRAIN, 12/16-CUSTOM,13-GLUTEN-FREE, to signal
that you can add cereals, fruit, nuts or other ingredients, (to 50-80 g appropriate).
• when the programme is finished,
• when the temperature maintenance mode is finished,
• when a safety feature is activated.
Caution: Sound signal activated by pressing the buttons can be deactivated by
simultanous pressing and holding both Time buttons (TIME+ and TIME-) for approx.
3 seconds. A beep will be heard and the sound signal is deactivated. Use the same
Memory in case of a power cut
If a power cut occurs while the bread maker is in operation, the bread maker will retain its
settings for 10 minutes. If the power cut lasts longer than 10 minutes, the process cannot be
restarted and the bread maker needs to be switched on again.
processing phases of the programme 12/16-BASIC.
procedure to switch on the signals.
Note
Caution
37 / 81
EN