Maintenance, Care And Storage; Changing The Roller; Ordering Spare Parts - EINHELL Gardol GEV 1400-33 Originalbetriebsanleitung

Anleitung GLV_1400_33_SPK7:_
avoid bare strips.
As soon as grass clippings start to trail the scarifier, it
is time to empty the grass basket.
Important! Before taking off the grass basket,
switch off the motor and wait until the roller has
come to a stop.
To remove the grass basket, lift up the ejector flap
with one hand, while unhooking the basket with the
other.
How frequently you should scarify your lawn is
determined primarily by the speed at which the grass
grows and the hardness of the soil.
Keep the underside of the equipment clean and
remove soil and grass build-up. Deposits make it
more difficult to start the aerator and decrease the
quality of the scarifying.
Always scarify along inclines (not up and down).
Switch off the motor before doing any checks on the
roller.
Important!
The roller rotates for a few seconds after the motor is
switched off. Never attempt to stop the roller. In the
event that the rotating roller strikes an object,
immediately switch off the equipment and wait for the
roller to come to a complete stop. Then inspect the
condition of the roller. Replace any parts that are
damaged (see section 10).
Lay the power cable on the ground in loops in front of
the power outlet. Scarify away from the power outlet
and cable, making sure that the power cable always
trails in the already scarified grass so that the
equipment does not travel over the cable.

9. Maintenance, care and storage

Maintenance and cleaning work on the equipment as
well as removal of the safety devices may only be
performed when the motor is switched off and the
power cable has been pulled.
Replace a worn or damaged roller immediately.
Do not clean the equipment with running water and
particularly not with a pressure hose.
Ensure that all mounting components (i.e. screws,
nuts etc.) are always tightened so that the equipment
can be safely operated at all times.
Store the equipment in a dry room. In order to ensure
that you enjoy your scarifier for many years to come,
15.09.2010 8:22 Uhr Seite 19
all screwed parts, as well as the wheels and axles,
should be cleaned and lubricated.
Keeping your scarifier in good condition not only
ensures a long lifespan and high performance, but
also enables the equipment to thoroughly scarify
your grass with minimal effort. For best results, clean
the equipment with a brush or rag. Do not use any
solvents to remove dirt.
At the end of the season, perform a general
inspection of the equipment and remove any
deposits which may have accumulated.
At the start of each season, ensure that you check
the condition of the equipment. If repairs are
necessary, please contact one of our customer
service centers (see address on warranty certificate).
The push bar has a "P" and an "A" position (Fig. 17)
in order to save space during storage.
When the bar is moved to the "A" and "P" position,
the scarifier takes up less space and can be pushed
into a corner (Fig. 18/19).
10. Replacing the spike drum
For safety reasons, we recommend having the spike
drum replaced by an authorized professional (see
address on warranty certificate).
Important!
Wear work gloves!
Only replace the unit with a genuine Einhell spike
drum , as this will ensure top performance and safety
under all conditions.

11. Ordering spare parts

The following information should be given when
ordering replacement parts:
Model/type of the equipment
Art. No. of the equipment
ID No. of the equipment
Part number of the required spare part
For our latest prices and information please go to
www.isc-gmbh.info
GB
19