Operation; Care And Maintenance; Ordering Replacement Parts - EINHELL BG-HR 60Z Montageanleitung

Anleitung BG_HR_60_Z_SPK1__ 17.08.12 07:31 Seite 7
1. Assembly (Fig. 2-16)
Proceed in the order of the pictures.
Additional information:
Fig. 4: Assemble the foot pipes (2, 3, 12) with
pipe connectors (N). To ensure that you
do not damage the thread during the
assembly process, screw up the union
nut a few turns and then tighten it after
completing the assembly work.
Fig. 5: Slip the pipe (13) over the wheel axle
(14).
Fig. 6: Push the sleeve (F) and washer (D) on
to the axle.
Fig. 7: Push the wheel (15) and sleeve (E) on to
the wheel axle. Push the washer (D) on
to the axle and tighten the hexagonal nut
(H).
Fig. 10: Fit the spacer ring (K), insert the crank
(10) through the mounting hole in the
bearing (5) and tighten it.
Fig. 13: The drum (1) and the chassis must be
joined together with the screw (C) and the
nut (I).
Fig. 14: Use the pipe connector (N) to join
together the push bar (4) and the chassis
(11/19). Take care not to damage the
thread of the pipe connector.
Fig. 16 : Use clamp (P) to fasten the section of
hose leading to the bent hose connector
(Fig. 12/8).

2. Operation

The hose between the water tap and the hose cart
can be connected to the straight connector (Fig.
12/7). Important: Turn off the tap when not in use.

3. Care and maintenance

Check the hose connections regularly for leaks and
signs of damage.

4. Ordering replacement parts

Please quote the following data when ordering
replacement parts:
Type of machine
n
Article number of the machine
n
Identification number of the machine
n
Replacement part number of the part required
n
For our latest prices and information please go to
www.isc-gmbh.info
5. Disposal
Accessories and packaging should be disposed of by
environment-friendly recycling. Plastic parts are
marked to enable properly sorted recycling.
GB
7