Disposal And Recycling; Cleaning, Maintenance And Ordering Of Spare Parts - EINHELL GE-CF 18/2200 Li Originalbetriebsanleitung

5.6 Fastening the cordless blower
Using the various recesses in the bottom of the
foot you can quickly fasten the cordless blower in
a variety of ways.
•
Hook (Fig. 6/Item 6): With the hook you can
fasten the cordless blower quickly and secu-
rely to a handrail, for example, or to scaffol-
ding.
•
Serrated edge (Fig. 7/Item 5): Using the ser-
rated edge you can hang the cordless blower
on a nail or the like. The fine ribbing is ideal
for balancing the cordless blower.
•
Fastening eyelet (Fig. 8/Item 4): Using the fas-
tening eyelet and a matching pan-head screw
you can hang the cordless blower on the wall.
5.7 Battery capacity indicator (Fig. 9)
Press the button for the battery capacity indicator
(c). The battery capacity indicator (d) shows the
charge status of the battery using 3 LEDs.
All 3 LEDs are lit:
The battery is fully charged.
2 or 1 LED(s) are lit:
The battery has an adequate remaining charge.
1 LED fl ashes:
The battery is empty, recharge the battery.
All LEDs blink:
The battery temperature is too low. Remove the
battery from the equipment, keep it at room tem-
perature for one day. If the fault reoccurs, this me-
ans that the rechargeable battery has undergone
exhaustive discharge and is defective. Remove
the battery from the equipment. Never use or
charge a defective battery.
6. Cleaning, maintenance and
ordering of spare parts
Danger!
Always pull out the battery pack before starting
any cleaning work.
6.1 Cleaning
•
Keep all safety devices, air vents and the
motor housing free of dirt and dust as far as
possible. Wipe the equipment with a clean
cloth or blow it with compressed air at low
pressure.
•
We recommend that you clean the device
GB
immediately each time you have finished
using it.
•
Clean the equipment regularly with a moist
cloth and some soft soap. Do not use
cleaning agents or solvents; these could at-
tack the plastic parts of the equipment. Ensu-
re that no water can seep into the device. The
ingress of water into an electric tool increases
the risk of an electric shock.
6.2 Maintenance
There are no parts inside the equipment which
require additional maintenance.
6.3 Ordering replacement parts:
Please quote the following data when ordering
replacement parts:
•
Type of machine
•
Article number of the machine
•
Identification number of the machine
•
Replacement part number of the part required
For our latest prices and information please go to
www.Einhell-Service.com

7. Disposal and recycling

The equipment is supplied in packaging to pre-
vent it from being damaged in transit. The raw
materials in this packaging can be reused or
recycled. The equipment and its accessories are
made of various types of material, such as metal
and plastic. Never place defective equipment in
your household refuse. The equipment should
be taken to a suitable collection center for proper
disposal. If you do not know the whereabouts of
such a collection point, you should ask in your
local council offi ces.
8. Storage
Store the equipment and accessories in a dark
and dry place at above freezing temperature.
The ideal storage temperature is between 5 and
30 °C. Store the electric tool in its original pa-
ckaging. If the appliance is to be stored unused
for a long period, the batteries are removed.
- 15 -