VOLTCRAFT 1665555 Bedienungsanleitung Seite 54

Proceed as follows to measure alternating currents (A
- Turn on the DMM using the rotary switch (13) and select the measuring range "A
display shows "A" and the symbol for alternating current "
- In the alternating current measuring range,
the display is set to zero automatically when
the clamp is closed. If a strong magnetic
field in the vicinity is affecting the display,
you can compensate this undesired display
value using the REL function (relative value
measurement).
- Push the open lever (4) to open the current
clamp.
- Clamp the individual conductor to be
measured and reclose the clamp. Position the
conductor in the middle of the two triangular
position symbols on the clamp.
- The alternating current is shown in the large
display, the frequency in the small display
above it.
- Remove the clamp from the measuring object and turn off the device after measurement.
Turn the rotary switch to "OFF".
54
)
".
VC-590OLED SE
". The