GF SPC D/PID Bedienungsanleitung Seite 39

Operating Instructions
Parameterize process controller
P.CONTROL - Settings
PID.PARAMETER
DBND 0.1%
KP 0.00
TN 0.5
TV 0.0
X0 0.0%
FILTER 0
SETUP
PV-INPUT
PV-SCALE
SP-INPUT
MENU Press for 3 s. Change from process level to setting level.
P.CONTROL P.CONTROL selection. Selection in the main menu (MAIN).
ENTER selection. The sub-menu items for the basic setting are displayed.
PID.PARAMETER selection.
ENTER selection. The menu for parameterizing the process controller is displayed.
The parameterization is described in the operating instructions in chapter "PID.
PARAMETER – Parameterization of the process controller".
EXIT selection. Return to P.CONTROL.
EXIT selection. Return to the main menu (MAIN).
EXIT selection. Change from setting level to process level.
You have parametrized the process controller.
Parametrization of the process controller
Insensitivity range (dead band) of the PID process controller
Gain factor of the process controller
Reset time in seconds
Hold-off time in seconds
Operating point
Filtering of the process actual value input
Setting up the process controller
Specification of the signal type for process actual value
Scaling of the process controller
Type of setpoint input (internal or external)
Type SPC D/PID positioner
39