Specifications - GF SPC D/PID Bedienungsanleitung

Type SPC D/PID positioner
5.4

Specifications

5.4.1 PROFINET IO-Specifications
PROFINET
DNS compatible name
Fixed IP address
Network mask
Default gateway
According to the PROFINET specification, these factory settings allow address assignment via the
DCP and LLDP services. Thus no additional tools and no new project engineering are necessary in
case of a device exchange.
Topology detection
Minimum cycle time
IRT
MRP Media redundancy
Other supported functions
Transmission speed
Data transport layer
PROFINET IO specification
(AR) Application Relations
5.4.2 EtherNet/IP-Specifications
EtherNet/IP
Fixed IP address
Network mask
Default gateway
Predefined default objects
DHCP
BOOTP
Transmission speed
Duplex modes
MDI modes
Data transport layer
Address Conflict Detection (ACD)
DLR (ring topology)
CIP reset service
5.4.3 Modbus TCP-Specifications
Modbus TCP
Fixed IP address
Network mask
Default gateway
Modbus function codes
Mode
Transmission speed
Data transport layer
26
no entry
0.0.0.0
0.0.0.0
0.0.0.0
LLDP, SNMP V1, MIB2, Physical Device
10 ms
not supported
MRP client is supported
DCP, VLAN priority tagging, shared device
100 MBit/s
Ethernet II, IEEE 802.3
V2.3
The device can handle up to 2 IO-ARs, 1 Supervisor AR and 1
Supervisor-DA AR simultaneously.
192.168.0.100
255.255.255.0
192.168.0.1
Identity Object (0x01)
Message Router Object (0x02)
Assembly Object (0x04)
Connection Manager (0x06)
DLR Object (0x47)
QoS Object (0x48)
TCP/IP Interface Object (0xF5)
Ethernet Link Object (0xF6)
supports
supports
10 and 100 MBit/s
half duplex, full duplex, autonegotiation
MDI, MDI-X, Auto-MDIX
Ethernet II, IEEE 802.3
supported
supported
Identity Object Reset Service Type 0 and 1
192.168.0.100
255.255.255.0
192.168.0.1
1, 2, 3, 4, 6, 15, 16, 23
Message Mode: Server
10 and 100 MBit/s
Ethernet II, IEEE 802.3
Operating Instructions