Cleaning And Care; Troubleshooting - Klarstein 10031757 Handbuch

• Before cleaning and any handling of the induction hob, unplug it from the power outlet and allow the hob
to cool!
• Keep the hob out of reach of children until it cools!
• After cooling, clean the ceramic glass cooktop and the control panel of the hob with a cloth and use a cloth
moistened with dish detergent for more soiled places.
CAUTION: Do not use abrasive sponges or scouring powder. Do not immerse the induction hob and the
power cord in water!
• Keep the top of the hob clean all the time to prevent accumulation of dirt around the fan and its possible
failure. Wipe the dust from the area of air circulation openings using cotton buds or a toothbrush with a small
amount of non agressive cleaning detergent and carefully remove oil stains.
• Clean carefully the remnants of cleaning agents off the cooktop with damp cloth, otherwise they can burn
when the hob is turned on.
Error Code Possible Cause
EO An unsuitable pot/pan is on the induction
zone or the diameter of the pot/pan is less
than 12 cm.
E1 Bad connection of the induction hob/
faulty electrical circuit.
E2 Problem with the temperature sensor.
E3 Voltage is too high.
E4 Voltage is too low .
ES Protection against overheating - the
cooktop is too hot .
E6 Problem with the fan, the air intake/
outflow is blocked.

Cleaning and Care

Troubleshooting

Suggested Solution
Place suitable cookware on the cooktop.
Contact an authorized service center.
Contact an authorized service center.
Check the power source, turn on when the
power source returns to normal.
Check the power source, turn on when the
power source returns to normal.
Wait few minutes until the appliance cools;
check the pot/pan.
When the appliance cools down, clean
the openings. Afterwards, restart the
appliance. If the problem persists, contact
an authorized service center.
16