Dmx Operation - EuroLite LED PR-100/32 Bedienungsanleitung

Interconnecting several devices (master/slave operation)
Several devices may be interconnected (max. 32). Then all slave units can be synchronized and controlled
with the master unit without the need for a DMX controller. The devices must be set to the corresponding
operating modes.
1 Configure all slave units before connecting the master unit: Press the MENU button so many times until
SLAU is indicated in the display. Confirm with the ENTER button.
2 Connect the DMX output of the master unit to the DMX input of the first slave unit. Then connect the
DMX output of the first slave unit to the DMX input of the second slave unit, etc. until all units have been
connected in a chain. Make sure the master unit is the first in the chain. Do not connect a DMX controller
to the DMX input of the master unit.
3 Set the master unit to the desired operating mode. The interconnected devices will now operate in sync.

DMX operation

Setting the number of DMX channels and the DMX starting address
For operation with a controller with DMX512 protocol, the device is equipped with 96 control channels.
However, it can also be switched to a mode with 3, 5, 8, or 48 channels if different functions are required. To
be able to operate the device with a DMX controller, the DMX starting address must be set. The starting
address depends upon which DMX controller is being used. Please refer to the controller's documentation.
1 Press the MENU button so many times until Addr is indicated in the display. Confirm with the ENTER
button.
2 The display indicates 3 CH (3 DMX channels), 5 CH (5 DMX channels), 8 CH (8 DMX channels), 48 CH
(48 DMX channels), or 96 CH (96 DMX channels). Use the buttons UP and DOWN to select the desired
number of DMX channels. Confirm with the ENTER button.
3 Now the display indicates the menu item for the DMX start address d***. Use the buttons UP and DOWN
to set the address. Confirm with the ENTER button.
4 The display will not flash when DMX signals are being received. If no control signals are available, the
display will flash.
Note: Please make sure that you do not have any overlapping channels in order to control each device
correctly and independently from any other fixture on the DMX chain. If several devices are addressed
similarly, they will work synchronically.
Functions in DMX mode
3-channel mode
Channel
1
2
3
5-channel mode
Channel
1
2
3
4
Master dimmer
5
Value
000 – 255 Red 0-100%
000 – 255 Green 0-100%
000 – 255
Blue 0-100%
Value
000 – 255 Red 0-100%
000 – 255 Green 0-100%
000 – 255 Blue 0-100%
000 – 255 Increasing brightness 0-100%
000 – 000 No function
001 – 005 Sound control (15 colors)
006 – 010 No function
011 – 255 Strobe with increasing speed (0-100%)
24/28
Function
Function
00129807, Version 1.0