Additional Functions; A) Hold Function; Display Lighting; Cleaning And Maintenance - VOLTCRAFT VC-125 Bedienungsanleitung

9. ADDITIONAL fUNCTIONS

a) hOLD function

The HOLD function keeps the currently indicated measured value in the displays to allow you to read or record it
easily.
If you test live wires, make sure that this function is deactivated before the measurement starts.
Otherwise, the measurement will be incorrect!
Also observe that the hOLD button was not pushed at the beginning of the measurement (display
with the hOLD button pushed: "hOLD"). If the hOLD button is pushed at commencement of
measuring, no measured value is displayed!
Push the button "HOLD" (2) to activate the hold function. The button latches and the display shows "HOLD".
Push the button "HOLD" to deactivate the HOLD function. The display "HOLD" goes out.
b) Display Lighting
With the DMM on, the lighting button with latching function (9) switches the display lighting on and off. Every push
will switch the lighting on or off. The lighting only remains on until the function is deactivated via the lighting button
(9) or the dial switch (position "OFF").

10. CLEANING AND MAINTENANCE

a) General Information
To ensure accuracy of the multimeter over an extended period of time, it should be calibrated once a year.
Apart from occasional cleaning and battery and fuse replacements, the meter requires no servicing.
Notes on replacing the fuses and battery are provided below.
Regularly check the technical safety of the device and measuring lines, e.g. check for damage to
the casing or squeezing, etc.
38