Status Display - Charging Process - Antenna; Battery Led; Power Led; Connecting The Antenna - Xoro PTL 1400 V2 Bedienungsanleitung

Status display - Charging process - Antenna

The LEDs on the front panel indicate the charging status of the built-in battery and the operating status
of the TV.

Battery LED

Colour
RED The television is supplied with power. Battery is charging.
A complete charging process takes about 4.5 hours (main switch in position OFF) or
approx. 6.5 hours (main switch in position ON).
The television is supplied with power. The battery is not charging because the tem-
Flashing
RED perature is too high. Move the TV to a cooler place and try charging the battery again
after about 30-60 minutes.
The television is supplied with power. Battery is fully charged.
GREEN
"Off" TV is not supplied with power. Power supply or vehicle power cable not connected.
Note:
While you are watching TV, the approximate charging status of the battery is displayed when you
change channels or press the SCREEN key. If the TV is connected to the power supply or the vehicle
power cable, the charge level cannot be displayed.

Power LED

Colour
RED The main switch is in the ON position. The television is in standby mode (standby
operation).
The TV can be switched on with the
holding the EXIT/
The main switch is in the ON position. The TV is switched on.
GREEN
"Off" The main switch is in the OFF position, the TV is disconnected from the power supply
or the battery is completely discharged.

Connecting the antenna

Connect the supplied antenna to the ANTENNA socket (see Page 7).
Note:
The supplied antenna is not the optimal choice for every reception area. Ask your local dealer for
information on selecting the right antenna.
Meaning
Meaning
key on the remote control or by pressing and
key directly on the TV.
EN 11