Xoro PTL 1400 V2 Bedienungsanleitung Seite 51

Troubleshooting
Symptoms
The LED on the vehicle
power cable does not light
up. The TV is not supplied
with power.
• The voltage at the input of the vehicle power cable is too high or too
low.
• The output of the vehicle power cable is overloaded or short-circuit-
ed. Disconnect the TV from the cable and check that the LED is lit.
Contact the XORO customer service.
• The tip of the vehicle power cable can be unscrewed for checking
and changing the fuse.
ATTENTION: The fuse may only be replaced by a fuse with identical
values. The fuse only responds in case of extreme overload. When
replacing a defective fuse, the vehicle electrical system, the television
and the general function of the vehicle power cable must therefore also
be checked. Consult a specialist.
EN 26
Cause and solution