Installation - Pkm GT 181A+++ Bedienungsanleitung

Do not use a socket board or a multi socket when using 220 240 V/50
Hz alternate current (AC). All electrical connections which may be
damaged must be repaired by a qualified professional.
1. Unpack the appliance carefully. Dispose of the packaging as described in
chapter waste management.
2. Completely remove the transport-protection. Be very careful and do not use any
aggressive or abrasive detergents to remove residuals of the transport-
protection.
3. Install the appliance in a suitable position with an adequate distance from
sources of heat and cold.
4. Check that the appliance and the power cord are not damaged.
5. Install the appliance in a dry and well-ventilated place.
6. Protect the appliance from direct sunlight.
7. Do not install the appliance in a place where it may come in contact with
water/rain; otherwise the insulation of the electrical system will be damaged.
8. The doors must open completely and without hindrance.
9. Install the appliance on a level, dry and solid floor. Check the correct installation
with a bubble level.
10. Connect the appliance to the mains properly.
11. The nameplate is situated inside the appliance or at the back.
WARNING!
1. An electrical supply of 220-240V AC / 50 Hz is required.
2. Connect the appliance to a suitable and dedicated socket only.
3. For your personal safety, the appliance must be grounded. The appliance is
equipped with a 3-pole safety plug. Use a suitable socket to minimize the risk of
an electric shock.
4. Check if the technical data of your energy supply meet the values on the
nameplate.
5. The plug must always be easily accessible after installation.

5. INSTALLATION

All repairs should be performed
by your authorized after sales service.
Unpacking and Positioning
Electrical connection
Do not connect the appliance to the mains
unless you have removed the complete packaging.
WARNING!
32