Inhaltsverzeichnis
Werbung
BRAKE PEDAL HEIGHT ADJUSTMENT/BRAKE SHOE
Å
ı
INSPECTION/SPROCKETS INSPECTION
BRAKE PEDAL HEIGHT ADJUSTMENT
1. Check:
Brake pedal height a
Out of specification → Adjust.
Brake pedal height a:
1 mm (0.04 in)
2. Adjust:
Brake pedal height
Pedal height adjustment steps:
Loosen the locknut 1.
Turn the adjusting bolt 2 until the pedal
height a is within specified height.
Tighten the locknut.
BRAKE SHOE INSPECTION
1. Inspect:
Brake shoe lining wear limit
Brake shoe lining wear limit checking
steps:
Fully pull in the brake lever (push down
the pedal) and hold it in position.
Then check the brake shoe wear indicator
1 is within the wear limit a.
Outside the limit →
Refer to "FRONT WHEEL AND FRONT
BRAKE" or "REAR WHEEL AND REAR
BRAKE" section in the CHAPTER 5.
Å Front
ı Rear
SPROCKETS INSPECTION
1. Inspect:
Sprocket teeth a
Excessive wear → Replace.
NOTE:
Replace the drive, driven sprockets and drive
chain as a set.
3 - 16
INSP
ADJ
Replace the brake
shoe.
Werbung
Inhaltsverzeichnis
