Specifications; Specific Safety Rules; Functional Description - Makita JS8000 Betriebsanleitung

ENGLISH
1. Switch trigger
2. Lock button
3. Hook
4. Hex wrench
5. Loosen

SPECIFICATIONS

Max. cutting capacities
Strokes per minute (min
Overall length
• Due to our continuing program of research and development, the specifications herein are subject to change without
notice.
• Note: Specifications may differ from country to country.
Symbols
The following show the symbols used for the equipment.
Be sure that you understand their meaning before use.
............... Read instruction manual.
................ DOUBLE INSULATION
Intended use
The tool is intended for cutting fiber cement material only.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and can
only be operated on single-phase AC supply. They are
double-insulated in accordance with European Standard
and can, therefore, also be used from sockets without
earth wire.

SPECIFIC SAFETY RULES

DO NOT let comfort or familiarity with product (gained
from repeated use) replace strict adherence to
cement shear safety rules. If you use this power tool
unsafely or incorrectly, you can suffer serious
personal injury.
1. Hold the tool firmly.
2. Secure the workpiece firmly.
3. Keep hands away from moving parts.
4. Edges and chips of the workpiece are sharp. Wear
gloves. It is also recommended that you put on
thickly bottomed shoes to prevent injury.
5. Do not put the tool on the chips of the workpiece.
Otherwise it can cause damage and trouble on the
tool.
6. Do not leave the tool running. Operate the tool
only when hand-held.
7. Always be sure you have a firm footing. Be sure
no one is below when using the tool in high
locations.
4
Explanation of general view
6. Screws
7. Cutting head
8. Side blade
9. Center blade
10. Pivot sleeve
Model
Fiber cement material
-1
)
Net weight
Safety class
8. Do not touch the blade or the workpiece
END201-2
immediately after operation; they may be
extremely hot and could burn your skin.
9. Avoid cutting electrical wires. It can cause serious
accident by electric shock.
10. Some material contains chemicals which may be
toxic. Take caution to prevent dust inhalation and
skin contact. Follow material supplier safety data.
11. Always use the correct dust mask/respirator for
the material and application you are working with.
ENE065-1
SAVE THESE INSTRUCTIONS.
ENF002-1
WARNING:
MISUSE or failure to follow the safety rules stated in
this instruction manual may cause serious personal
injury.

FUNCTIONAL DESCRIPTION

CAUTION:
GEB032-1
• Always be sure that the tool is switched off and
unplugged before adjusting or checking function on the
tool.
Switch action (Fig. 1)
CAUTION:
• Before plugging in the tool, always check to see that
the switch trigger actuates properly and returns to the
"OFF" position when released.
To start the tool, simply pull the switch trigger. Tool speed
is increased by increasing pressure on the switch trigger.
Release the switch trigger to stop.
For continuous operation, pull the switch trigger and then
push in the lock button.
To stop the tool from the locked position, pull the switch
trigger fully, then release it.
Hook (Fig. 2 & 3)
The hook is convenient for temporary hanging the tool.
11. Spacer
12. Reposition end-to-end
13. Reposition left-to-right
14. Tighten
JS8000
8 mm
0 - 2,500
346 mm
2.1 kg
/II