Important Information; Parts Identification - Panasonic EW1614 Bedienungsanleitung

Important information

►Notice
• Do not put salt, mouthwash or other chemicals into the
water tank. Doing so may cause malfunction.
• Do not dry the main unit with a dryer or a fan heater.
Doing so may cause malfunction or deformation of the
parts.
• Store the appliance in a place with low humidity after
use. Failure to do so may cause malfunction.
• About tooth tartar
Please use together with a toothbrush.
It is hard to remove tooth tartar or dental calculus
attached to the tooth surface just by a water jet, so a
toothbrush is required to brush the teeth.
It is recommended to clean inside your mouth with the
water jet after brushing your teeth.
• About bleeding gums
Initially bleeding may occur even with healthy gums.
This is caused because the gums are not used to such
stimulation. The bleeding will normally stop within
1 or 2 weeks of use. There may be a problem with
the gums (periodontal disease, etc.) if the bleeding
continues for over 2 weeks. In such cases, stop using
the appliance andconsult a dentist.
10
Parts identification
Handle
A
1 Stop/Jet switch
2 Jet mode " "
3 Stop mode " "
4 Nozzle release button
5 Nozzle
Main unit
B
6 Cord
7 Power plug
8 Suction hose
Water tank
C
9 Upper water level limit
 Water tank cap
Operation panel
D
 Water pressure
level LED indicator
(1~10 levels)
(Level 1 is also the
Child mode " " .)
 Power switch " "
 Water pressure
regulator switch
Ultrasonic nozzle (x2)
E
q Nozzle
w Nozzle insertion port
Orthodontic nozzle
F
q Nozzle
w Nozzle insertion port
e Identification ring
r Nozzle Handle
Tongue care nozzle
G
q Nozzle
w Nozzle insertion port
e Identification ring
t Cloth
• All of the nozzles are
consumables.
Accessory
Nozzle stand
H
There may be moisture inside the main
unit (water tank and suction hose) left
from the distilled water used for product
testing.
■ If the identification ring comes off
(For orthodontic nozzle and
tongue care nozzle only)
Align the identification ring (in any
direction) with the nozzle, and
attach them without any inclination.
• Even if the identification ring is
not attached, it does not affect the
performance of the nozzle.