Installation Instructions - Novy Flex Zone Montage- Und Bedienungsanleitung

INSTALLATION INSTRUCTIONS

The installation comes under the exclusive responsibility of specialists.
The installer is held to respect the legislation and the standards enforce in his home country.
How to stick the gasket:
The gasket supplied with the hob avoids all infiltration of liquids in the cabinet.
His installation has to be done carelessly, in conformity of the following drawing.
Fitting - installing:
 The cut out sizes are:
Type Cut size
Width Depth
1706 985
1786 805
 The piece of furniture or the support in which the hob is to be fitted, as well as the
edges of furniture, the laminate coatings and the glue used to fix them, must be able to
resist temperatures of up to 100 °C.
 The mural rods of edge must be heat-resisting.
 The hobs are classified as "Y" class for heat protection. Ideally the hob should be
installed with plenty of space on either side. There may be a wall at the rear and tall
units or a wall at one side. On the other side, however, no unit or divider must stand
higher than the hob.
 Ensure that there is a distance of 50 mm between the hob and the wall or sides.
 Materials which are often used to make worktops expand on contact with water. To
protect the cut out edge, apply a coat of varnish or special sealant. Particular care must
be given to applying the adhesive joint supplied with the hob to prevent any leakage
into the supporting furniture. This gasket guaranties a correct seal when used in
conjunction with smooth work top surfaces.
 Not to install the hob to the top of a not ventilated oven or a dishwasher.
 To guarantee under the bottom of the hob casing a space of 20 mm to ensure a good
air circulation of the electronic device.
 To guarantee between the work top and the top of the drawer or oven a space of 5 mm
to allow the exit of the air flow.
 If a drawer is placed under the work, avoid to put into this drawer flammable objects
(for example : sprays) or not heat-resistant objects.
 The safety gap between the hob and the cooker hood placed above must respect the
indications of the hood manufacturer. In case of absence of instructions respect a
distance minimum of 760 mm.
 The connection cord should be subjected, after builting, with no mechanical constraint,
such for example of the fact of the drawer.
 The installation of the hob in non stationary sites ( for example : boat ) should be
undertaken by specialists.
Glass size
Width Depth
380 1000 400
490 880 520
Stick the gasket (2) two millimeters
from the external edge of the glass,
after removing the protection sheet (3).
Cut size of flush mouting
Thickness Width
4 1006
4 886
54
Depth Thickness
406 4
526 4
Radius
7
7