Replacing The Power Cable; Cleaning, Maintenance And Ordering Of Spare Parts; Carbon Brushes - EINHELL TE-DW 180 Originalbetriebsanleitung

6.4 Working with the wall processing system
•
Place the whole surface area of the grinding/
sanding disk, steel brush or concrete cutter
on the wall.
•
Switch on the machine and perform circular,
vertical, horizontal or diagonal movements
with moderate pressure over the material you
wish to work on.
•
Use a coarse grit for coarse sanding and a
finer grit for finish sanding. You can find the
best grit size for the job by carrying out san-
ding tests.
Removing wallpaper and wallpaper residue
Speed: 3-5
Tool: Abrasive paper, steel brush
Sanding wood
Speed: 4-5
Tool: Abrasive paper
Smoothing fi lling material on plasterboard
Speed: 4-5
Tool: Abrasive paper
Removing and smoothing plaster surfaces
Speed: 4-6
Tool: Abrasive paper / steel brush
Removing carpet adhesive residue
Speed: 4-6
Tool: Abrasive paper / steel brush / diamond grin-
ding cup
Removing tile adhesive residue
Speed: 4-6
Tool: Abrasive paper / diamond grinding cup
Cutting concrete
Speed: 6
Tool: Diamond grinding cup
Caution:
The dusts that are generated while the equipment
is being used can pose a health hazard:
•
Always wear safety goggles and a dust mask
during sanding work.
•
All persons who work with the equipment or
enter the workplace must wear a protective
dust mask.
•
Eating, drinking and smoking are prohibited
at the workplace.
•
Never use this tool to work on paints that con-
tain lead!
Anl_TE_DW_180_SPK9.indb 19 Anl_TE_DW_180_SPK9.indb 19
GB

7. Replacing the power cable

Danger!
If the power cable for this equipment is damaged,
it must be replaced by the manufacturer or its
after-sales service or similarly trained personnel
to avoid danger.
8. Cleaning, maintenance and
ordering of spare parts
Danger!
Always pull out the mains power plug before star-
ting any cleaning work.
8.1 Cleaning
•
Keep all safety devices, air vents and the
motor housing free of dirt and dust as far as
possible. Wipe the equipment with a clean
cloth or blow it with compressed air at low
pressure.
•
We recommend that you clean the device
immediately each time you have finished
using it.
•
Clean the equipment regularly with a moist
cloth and some soft soap. Do not use
cleaning agents or solvents; these could at-
tack the plastic parts of the equipment. Ensu-
re that no water can seep into the device. The
ingress of water into an electric tool increases
the risk of an electric shock.

8.2 Carbon brushes

In case of excessive sparking, have the carbon
brushes checked only by a qualifi ed electrician.
Danger! The carbon brushes should not be rep
laced by anyone but a qualifi ed electrician.
8.3 Maintenance
There are no parts inside the equipment which
require additional maintenance.
- 19 -
25.09.2018 09:00:34 25.09.2018 09:00:34