Seat Adjustment - Axkid Nextkid Bedienungsanleitung

Restraining your child
5. Place your child in the child car seat and pull the shoulder strap through the green shoulder strap guide (C) .
6. Move the belt in front of the child to the vechicle belt buckle. Insert the seat belt into the vechicle belt buckle
and make sure that you hear a click.
7. Pass the lap belt through the green lap belt side guide .
WEIGHT: Tighten the strap in the protruding area and check the taut fit.

Seat adjustment

8. Pull the Headrest Adjusting Handle (H)upward to proper height, making sure the Shoulder Belt is level with
your child's shoulder;
9. The correct height of the headrest is when there is 1 cm between the child's shoulder and the lower edge
of the headrest (A). Once the right fit is found release the handle and check the headrest to ensure it is
locked into position.
10. Pull the SIP Bumper Controller(J) to unlock and pull outward or push inward then you can make di erent
sized according to Car's internal Situation. It can also be adjusted on one side.
11. Pull out the angle adjusting handle(L) on the front of the seat, meanwhile move the back of the seat to
di erent angles. Adjust the seat into proper angle before fastening the belt on the child.
(there are 4 positions. )
IMPORTANT: NEVER place your child in the Axkid Nextkid whilst it is not fitted in a car,The car seat should never be
used free-standing as it may tip backwards.
MPORTANT: The lap belt is worn low over the hips. Check that the lap belt passes throuch both green lap belt side
quides . Check that the shoulder belt passes through the green shoulder belt guide (C) therdiagonally across the child's
chest and through the green lap belt side quidenearest to the seat belt buckle. Finally, chec!that all slack has been
removed from the vehicle seat belt.
IMPORTANT: Make sure the seat belt buckle is not wedged or interfering with the lap belt side guides .
WARNING: An unoccupied the Axkid Nextkid should be secured using a 3-point seat belt or the ISOFIX
connectors if available.
MPORTANT: DO NOT recline the child seat's backrest beyond the allowable adjustable range.lf you hear a loud
"clickwhilst adiusting the backrest, then you have gone past the allowable range. Reclining the vehicle seat may
adverselya ect the position of the vehicle seat belt across the child and may result in death or serious injury during a
crash. Refer toyour vehicle owner's manual for adjusting the vehicle seat back with child seats.
10
Removing the car seat from your vehicle
To remove the Axkid Nextkid from the vehicle, press both ISOFIX buttons to release the Axkid Nextkid from the
ISOFX connection points(F) and lift the seat out of the vehicle.
Care and maintenance
• The Axkid Nextkid cover can be removed and washed in a washing machine at 30o C on the "Gentle Cycle"
program. Do not put the cover in a dryer as this can damage the cover and the padding may separate from the
fabric.
• Removing and refitting the seat covers.
o
Raise the headrest to its highest position to allow for more room to work.
o
Pull out the snap-fastener of the base cover and then pull down the base cover;
o
Pull out the cover of SIP Bumper from the rim of the seat and tear apart the macro tape.
o Get the rope out of the hook, pull the cover of the Shoulder Guide out and then pull the
whole headrest cover out
o
Visit www.axkid.com to find videos explaining how to remove and attach the cover.
• Any plastic parts of Axkid Nextkid can be cleaned with mild detergent and water. Do not use aggressive
chemicals containing solvents etc., as this can cause damage to the plastic and compromise the safety of
the car seat .
Do not make any modifications or alterations to Axkid Nextkid other than those described in this
•
instruction manual. Follow the instructions in this manual carefully. Anv repairs must be carried out
by the manufacture or agent.
• If the seat cover needs replacing, ensure only original products from Axkid are used. If other products are used,
the car seat safety system may be compromised and could lead to severe injury in case of an accident.
Recycling your base
Axkid strongly recommends recycling of old car seats. Before leaving the base at your local
recycling station separate metal and plastic parts if possible. The main part of the base should be
marked unsafe or expired (use a marker) to deter anyone from using it again. Please check your
local municipal guidelines for recycling instructions for the di erent materials.
Warranty
Axkid Nextkid is covered by a 24-month warranty from date of purchase. Ensure you save your receipt and bring it to your
place of purchase if you have any warranty issues.
The warranty does not cover:
• Normal wear and tear
• Damage due to incorrect use, neglect, or accident
• If repairs have been carried out by a third party
• All materials used have a very high UV-resistance rating. However, UV-light is very aggressive and will ultimately
lead to fading of the seat cover. This is not covered by our warranty as it is considered normal wear and tear.
11