Allowed And Disallowed Positioning Of Axkid Minikid 3 Car Seat; Lower Tether Anchorages - Axkid Minikid 3 Premium Bedienungsanleitung

Allowed and disallowed positioning of
Axkid Minikid 3 car seat
Axkid Minikid 3 car seat can only be installed rear-facing. It will fit in most, but not all seating positions. Check your vehicle instruction
manual to find suitable seating positions and check the vehicle list on www.axkid.com
Front passenger seat (no active airbag)
Front passenger seat (active airbag)
Rear passenger seat with 3-point seat belt
Seat with 2-point seat belt
Side and rear facing seats
IMPORTANT: If you wish to install your Axkid Minikid 3 car seat in a location where a frontal airbag is fitted, the airbag must be discon-
nected according to your vehicle manufacturer instruction. Note that some vehicles require an authorized service centre to disconnect
the airbag.
* The General Regulation of Traffic in Spain, in its article 117, establishes the prohibition of driving with children of stature equal to or less
than 135 centimetres located in the front seats of the vehicle, without exceptions.

Lower Tether Anchorages

Important info
Lower tether anchorages (LTA) are used to enhance the protection of children in cars by providing a firm and stable installation for
extended rear-facing belt attached car seats. This increases the safety for your child in all types of collisions, including roll-over accidents
and rear-end impacts.
Lower tethers are a well-established method that has been extensively used in the Nordic countries for over 40 years. In 2020 a new
international standard for LTA, ISO13216-4:2020, was released. This standard describes the requirements for lower tethers for car seats
but also for vehicle manufactures and their anchor points. The purpose is to improve the compatibility and ensuring a safe and easy way
of installation for the future.
Axkid Minikid 3 lower tethers complies with ISO13216-4:2020, ensuring a perfect fit and easy installation in vehicles with pre-installed
lower tether anchorages that also complies to this standard. If your vehicle has anchorage points that do not comply with the standard,
Axkid Minikid 3 lower tethers are still likely, but not guaranteed, to fit.
Pre-installed lower tether anchorages in vehicles are often found on the seat rails attached to the floor, but other positions are also used.
Check your vehicle' s instruction manual for more information on usable anchor points.
If your vehicle has no pre-installed lower tether anchorages, Axkid Minikid 3 comes with additional lower tether anchorage straps (S)
included that can be installed in your vehicle. See this manual for instructions of installation. These straps also comply to ISO13216-4:2020
and when installed correctly, offers the same safety as pre-installed anchorages.
Some vehicle manufactures also offers the possibility of retrofitting lower tether anchorages. Contact your vehicle manufacturer or dealer
for more information. Axkid retrofit lower tether anchorages and extra lower tether anchorage straps can be purchased separately.
Note: Never use Axkid Minikid 3 without the lower tethers. They are an important safety feature and must always be used when installing
your car seat.
YES/NO*
NO
YES
NO
NO
16 16