hanseatic HWD75T214DE Gebrauchsanleitung Seite 84

Page EN-40 Troubleshooting table
Malfunction
Problem
Error code on the
E04
display
The cycle duration dis-
played differs from the
actual duration of the
cycle.
Error code Possible causes
Loading door is not closed properly.
E01
Problem with the water inlet:
E02
Valve is closed.
Inlet hose is kinked.
Inlet hose is clogged.
Filter on inlet is clogged.
The water does not drain away.
E03
Too much water in the appliance.
E04
Possible causes
Too much water in the appliance.
This is not an error. The cycle dura-
tion is always adapted to the circum-
stances and re-calculated.
Error code
Solutions, tips
Pump out the water (see
page EN-19).
Switch the appliance off after the
water has been pumped out and
pull out the plug. Close the tap and
contact the service department (see
page EN-41).
Solutions, tips
Properly close the loading door (a "click" must
be heard).
Open valve.
Check inlet hose; dismantle if necessary and
re-align.
Clean filter on the inlet hose (see page EN-30).
Clean filter on inlet (see page EN-30).
Check whether the drainage hose is clogged or
bent.
Check whether the lint trap is clogged (see
page EN-31).
Pump out the water (see page EN-19)
Switch the appliance off after the water has
been pumped out and pull out the plug. Close
the tap and contact the service department (see
page EN-41).