Operation: Standard Cycles; Before Getting Started; Selecting The Cycle; Starting The Cycle - hanseatic HWD75T214DE Gebrauchsanleitung

Operation: Standard cycles

Before getting started

• First read chapter „Intended use" and
chapter „Safety notices" (from page EN-4).
• Remove the transport safety devices and
prepare the appliance as described in
chapter „Installation, connection and initial
commissioning" (see page EN-33).
• Properly attach the water inlet hose and
the water outlet hose.

Selecting the cycle

(2)
1. Use the cycle table to find the right cycle
for your laundry (see page EN-16).
2. Select the cycle using the cycle selector (2).
The display panel (9) shows the wash cy-
cle time.
You can change the selected cycle's
standard values to further adjust them to
your kind of laundry (see "Operation: Addi-
tional functions" on page EN-21).

Starting the cycle

(9)
1. Open the valve completely.
Operation: Standard cycles
2. Press the
The cycle starts.
The display panel (9) shows the remaining
cycle time.
Suspending and continuing
the cycle
To stop the current cycle,
• press the
The
ruption.
• Press the
the cycle.
Please note that a long pause can affect
the wash result, since the suds cool
down.

Suspending/altering the cycle

1. Turn the cycle selector (2) to "Off" to can-
cel an active cycle or to select an alterna-
tive cycle.
The programme ends.
2. Set the cycle selector (2) to any other cy-
cle in order to drain the soapy water.
The suds will be drained away.
3. To select a new cycle, set the cycle selec-
tor (2) to a new cycle.
4. If required, add extra detergent.
5. Start the new cycle with the

Cycle end

The appliance stops automatically as soon as
the selected cycle is finished.
1. If the "End" flashes on the display pan-
el (9), the loading door can be opened
and you can remove the laundry.
(3)
Page EN-19
button (3).
button (3).
button (3) will flash during the inter-
button (3) again to continue
button (3).