Yamaha GEP5O Bedienungsanleitung Seite 28

5: MIDI DATA FORMAT
1. Reception Conditions
MIDI TRG. (BASE KEY)
OOFF(OFF) |
. О - — $9n NOTE ON
MIDI CH . ON{CI--C6)
O OFF
OMNI "о
MIDI IN ——»O
$8n NOTE OFF
$Cn PROGRAM CHANGE
2. Reception Data
2-1. Channel Information
1) Channel Voice Message
@ NOTE ON © PROGRAM CHANGE
Can be received on the MIDI channel set in the
currently active bank.
In the case of effect 46 (Reverb & Gate), if the
. MIDI TRG parameter is ON a NOTE ON message
received will trigger the effect.
If effect 47 (Pitch A) is selected, the received NO-
TE ON data is used to set the pitch shift of the
effect. NOTE ON data will be ignored, however,
if the BASE KEY parameter is set to OFF.
|00їпппп (9nH) n=O (channel no.1)—
15 (channel no.16)
k=0 (C-2)—127 (G8)
v20—127
STATUS
NOTE NO. Okkkkkkk
VELOCITY ÜOvvvvvvv
Ө NOTE OFF
Although this message causes no direct action т.
the GEP50, it is essential to signal the end of
a NOTE ON message. The conditions for NOTE
OFF message reception are the same as for NO-
TE ON reception, as described above.
k=0 (C-2)—127 (G8)
:v=0-127
STATUS
· NOTE МО. Okkkkkkk
VELOCITY
Ovvvvvwv
29 СЕР50 GUITAR EFFECT PROCESSOR
Can be received on the MIDI channel set in the
currently active bank.
The effect assigned to the received program
number in the program assignment table will be
selected.
STATUS I100nnnn (CnH) n = 0 (channel по.1)-
15 (channel по.16)
PROGRAM Оррррррр р=0—127
NO.
|