Yamaha GEP5O Bedienungsanleitung Seite 10

Each of the GEP50 effects has a number of internal parameters
which may be edited by you to create a sound that is ideally
suited to your own specific musical requirements. А complete
description of each effect and its parameters is given in ^3, DE-
SCRIPTIONS OF THE EFFECTS & THEIR PARAMETERS" ON
PAGE 13. Using effect 1 (Mid-Band Drive) as an example, |
here's how. о: access and edit effect | parameters:
Mid-Band Drive
DISTORTION =100%
Mid-Band Drive |
TREBLE=1dB
Mid-Band Drive
MID FRQ=2.0kHz
Mid-Band Drive
MID GAIN-0dB |
Mid-Band Drive
BASS=0dB
Mid-Band Drive
TRG.LEVEL-35
Mid-Band Drive |
RELEASE=525ms|
Mid-Band Drive
BALANCE=100%
Mid-Band Drive
= 100 %
OUTLVL
GEP50 GUITAR EFFECT PROCESSOR
® Select and recall the effect to be edited (Mid-t -Band Drive for
this example). |
® Press the PARAMETER button and the first of the selected
"effects parameters will appear on the bottom line of the |
LCD. Each time the PARAMETER button is pressed, the :
next parameter on the selected effects "parameter list" will `
be called. With Mid-Band Drive, for example, the following
parameters : are called | in sequence: |
DISTORTION -> TREBLE => MID ЕВО — MID САМ — BASS
— ТАС. LEVEL — RELEASE — BALANCE — OUT LVL — and
back to DISTORTION
Note that the first parameter in the list is returned to if the
PARAMETER button is pressed after the last parameter
(OUT LVL м this example) has been called.
® Once the desired parameter has been called, its value is
edited by using the [A] and/or [V] buttons. The [A] button
increases (increments) the value while the [v] button
decreases (decrements) the value. Either button can be
held down for continuous incrementing or decrementing.
Mid-Band Drive
DISTORTION =100%
Mid-Band Drive
DISTORTION: 60%
New value
In this way you can go through and edit any number of the
parameters to create the sound you want. If, however, you
select and recall a new effect without first storing your ed-
ited parameters in a memory location between 51 and 00,
any changes you have made will be lost and will have to be
re-programmed. If you want to keep an edited effect, use
the STORE operation described below.