Werbung
Verfügbare Sprachen
Verfügbare Sprachen
23. Phase Dist.
|
Phasing plus distortion.
Distortion Level (DISTORTION): 0 — 100%
Sets the "degree" or "depth" of the distortion portion of the
effect.
Phase Balance (PHASE BAL): 0 — 100%
Determines the amount of phase effect applied to the distor-
tion sound.
Modulation Frequency (MOD. FRQ): 0.1 Hz — 20 Hz
Sets the speed of the effect variation.
Modulation Depth (MOD. DEPTH): 0% — 100%.
Sets the depth of the effect.
Modulation Delay (MOD. DLY): 0.1 — 8.0 milliseconds
This sets the basic delay time from the initial direct sound to
the beginning of the phase effect.
Trigger Level (TRG. LEVEL): 1 — 100
Determines the amplitude of the input signal required to
trigger the effect. This parameter, in conjunction with the
RELEASE parameter below, functions effectively as a noise
gate to cut out hiss and noise when an input signal is not
present. TRG
LEVEL should be set so that the effect is
activated only when a note is played on the instrument
used.
Release Time (RELEASE): 5 — 32000 milliseconds
Determines the amount of time it takes for the distortion
gate to close after the input signal drops below the trigger
_
level. Proper setting of the RELEASE parameter is essential
to allow a natural decay of the source instrument sound.
17
СЕР50 GUITAR EFFECT PROCESSOR
24. Symphonic Dist.
|
Symphonic plus distortion.
Distortion Level (DISTORTION): 0 — 10096
Sets the "degree" or "depth" of the distortion portion of the
effect.
Symphonic Balance (SYMPHO BAL): 0 — 100%
Determines the amount of symphonic effect applied to the
distortion sound.
Modulation Frequency (MOD. FRQ): 0.1 Hz — 20 Hz
Sets the speed of the effect variation.
Modulation Depth (MOD. DEPTH): 0% —
10076
Sets the depth of the effect.
Trigger Level (TRG. LEVEL): 1 — 100
Determines the amplitude of the input signal required to
trigger the effect. This parameter, in conjunction with the
RELEASE parameter below, functions effectively as a noise
gate to cut out hiss and noise when an input signal is not
present. TRG LEVEL should be set so that the effect is
activated only when a note is played on the instrument
used.
Release Time (RELEASE): 5 — 32000 milliseconds
Determines the amount of time it takes for the distortion
gate to close after the input signal drops below the trigger
level. Proper setting of the RELEASE parameter is essential
to allow a natural decay of the source instrument sound.
Werbung
