Blaupunkt BLUEBOT OMEGA Bedienungsanleitung Seite 4

Verfügbare Sprachen

SAFETY REGULATIONS

CLEANING AUTO STATION WARNINGS:

· Do not pull the power plug with a wet hand.

· Do not use a damaged power plug or a loose power socket.

· When using the cleaning auto station, please only use the oﬃcial AC power

supply as received with the station. Others may cause ﬁre or electric shocks.

· Please remove the dust on the power plug with a dry cloth at regular intervals

to avoid ﬁres due to poor maintenance.

· Please insert the power plug till the end to avoid electric shocks, short

circuit and fires.

· In the case of any fault, please cut oﬀ the power supply and stop using the

product immediately to avoid smoking, ﬁres and electric shocks.

· If the product is abnormally hot, has a burning smell or sounds abnormally in

charging or use, please cut oﬀ its power supply and pull its power plug immedi-

ately, put it in an open space away from combustibles and safely replaced or re-

paired by a full-time maintenance person of the manufacturer to avoid dangers.

· To avoid personal injuries and electric shocks, please pull the power plug from

the power socket before cleaning or maintaining it.

· Do not put the robot or the power plug into water, or spray water onto any

of them.

· Do not use any other power cable to charge the product.

· When pulling the power plug, hold the insulated part of the cleaning auto

station and not pulling the power cable.

· To avoid electric shocks, do not use the cleaning auto station when the shell is

damaged.

· The cleaning auto station only applies to the ﬂoor mopping robots designated

by the manufacturer.

· Before charging, please check whether the cleaning auto station's speciﬁcation

is consistent with the supply voltage.

· Make sure to empty the dirty water tank in time and reﬁll the clean water tank

in order for the robot to keep performing the mopping function.

WARNING: Do not put this robot in a place where it is easy to fall (e.g. on a desk,

chair of by the stair case). As the fall prevention sensors can get dirty or be blocked.