Werbung
Verfügbare Sprachen
Verfügbare Sprachen
5. USAGE OF THE ROBOT & AUTO STATION
CHARGING OF THE ROBOT
Press and hold the button
for 3 seconds to start the robot, and then
short-press the button
to make the robot recharge automatically. The
robot is ready once fully charged.
0.5m
• Fully charge the robot before starting cleaning.
• Before starting the cleaning, tidy away the wires and articles on the
ground to avoid damage caused by winding, dragging and bumping
during cleaning.
14
0.5m
1.6m
• It is suggested to start the robot at the auto station.
• When the battery is low during the cleaning, the robot will automatically
return to the auto station for charging, and automatically return to the
interrupted place to continue cleaning when the battery is full.
NOTES
· If the robot fails in operation, the ON/OFF button indicator will ash quickly in red,
accompanied with an audible alarm. Please eliminate the fault as instructed in the
"Troubleshooting" section in this manual.
· If there is no operation in more than 20 minutes, the robot will sleep automatically.
After that, it cannot be controlled by the auto cleaning station anymore and can be
wakened by pressing any button on the robot or operating it via the App.
· After cleaning, the robot will go back to the cleaning auto station automatically
for dust collection.
· If the robot cannot be started because of button operation failure, try the reset
system. After the reset button, the robot will be started automatically; after reset,
the product will clear the periodic cleaning setting and the cleaning mode setting
and reset the WiFi.
· Note: Make sure to save your map in the Bluebot app before reset, so you may
restore the existing map.
Werbung
