Werbung
Verfügbare Sprachen
Verfügbare Sprachen
INSTALLATION INSTRUCTIONS ROBOT & AUTO STATION
PRODUCT ASSEMBLY
1 Dismount the stopper protective sponges on two sides of the
bumper/stopper into the groove on the bottom;
2 Install the mop pad in the bonding area of the mop pad
holder and assemble the mop pad holder sub-assembly.
TIP: First time usage of the robot, we advise to use it without the mopping pad including
mopping cloths. In that way the robot can first only vacuum the required area, create a full
map in the Bluebot app and include carpet areas (without mopping).
10
3 Install the side brushes with a screwdriver until tight.
4 Fully charge the robot (before 1st time use)
5 Connect with Bluebot app (optional)
6 Start cleaning
NOTE
• Please do not move the auto station without reason and keep it out of direct sunlight.
• If the auto station is relocated, the robot may fail in positioning and lose the map. When
restarted, the robot will rebuild and memorise the map. In the rebuilt map the cleaning
information for forbidden areas and other areas may have been lost.
• Direct sunlight will interfere with the recharging signal and consequently, the robot
may be unable to return to the charging/ auto station.
• The robot cannot be used to remove liquids.
• If the battery level is less than 20% the machine will not work. Please charge it.
• The machine will return to the auto station automatically if the battery level is less than
20% when in use and will be powered o and then start cleaning automatically after the
battery level reaches 80%.
• Please clear various wires (including the power line of the auto station ) from the ground
before use to avoid outage and damage of objects or wires when wires are dragged by
the robot.
Werbung
