Werbung
Verfügbare Sprachen
Verfügbare Sprachen
MAINTENANCE
COMPONENT MAINTENANCE
Regular maintenance
To achieve the best cleaning effect, clean and maintain the robot regulary
according to below table. Determine the frequency of cleaning and
maintenance according to your use habits.
CLEANING
PARTS
FREQUENCY
Filter
Weekly
Roller brush
Weekly
Side brush
Monthly
Roller brush cover
Monthly
Sensor
Monthly
Charging pins
Monthly
Universal wheel
Monthly
Dust Bag
Dirty water tank
Every time its full or weekly
Clean water tank
Bi-weekly
REPLACEMENT
FREQUENCY
Every 2 months
Every 6 to 12 months
Every 3 to 6 months or when it
is obviously damaged
Every 3 to 6 months or when
the rubber silicon strip on the
roller brush cover is obviously
damaged
When it is obviously damaged
-
When it is obviously damaged
Replace when the auto station
prompts it is full of dust or
-
replace it once after using it
10 times.
Replace when damaged
Replace when damaged
BATTERY
· The robot is furnished with high-performance lithium-ion batteries.
· To maintain battery performance, please keep the robot charged in daily use
· If the machine is left unused for any length of time, please shut down and
keep it properly.
· Charge it at least every three months to avoid damaging batteries due to
excessive discharge.
FIRMWARE UPGRADE
· Upgrade firmware using the Bluebot app. If new firmware is detected, upgrade
it according to the report.
· The battery level should be ≥ 50% during firmware upgrade, so if needed the
robot should be placed on the charging station to charge before the firmware
upgrade takes place.
SYSTEM RESET
· Press the 'reset key' on the side of the robot for at least 5 seconds. Make sure
that you place the robot back on its charging station.
· The current map and timing will be lost, WIFI and personalised settings will be
reserved after reset.
FAULT STATE
If the robot encouters a fault while working, the power indicator blinks quickly
in red, and a voice prompt is generated.
NOTE
• If no operation is peformed beyond 10 minutes, the robot automatically enters in
sleep mode.
• Put the robot back to charging in fault state, the clenaing will end.
EN
25
Werbung
