Hendi 148105 Bedienungsanleitung Seite 7

•
H
D
Intended use
• The device is intended for professional use and
can be operated only by qualified personnel.
• This appliance is designed only for grilling appro-
priate food products. Any other use may lead to
damage to the appliance or personal injury.
Connecting the gas bottle
1 = Main tap
2 = Pressure regulator
3 = Gas hose
4 = Gas Bottle
5 = Rubber washer
Igniting the gas barbecue
• Always place the grids on the Powergrill.
• Press in and turn the Power knob to the 'Max' po-
sition, keep it pressed-in. Press the red ignition
knob in a few times till al the burners ignite fully.
Extinguishing the gas barbecue
Turn the knob completely to the right.
Note! After turning off the burner, wait approximately 10 minutes before reigniting the burner. After turning
off the burner, always turn off the main tap on the gas cylinder and the tap on the appliance!
The maximum cylinder dimensions(regulator included) should not
exceed (D)50x(H)75cm if no cylinder compartment included.
• Operating the appliance for any other purpose
shall be deemed a misuse of the device. The user
shall be solely liable for improper use of the de-
vice.
Attach the pressure regulator to the gas bottle
using the large brass nut. Always ensure that the
rubber-sealing washer is present in the nut. (NB.
This rubber washer is not required for UK-type
pressure regulators). Tighten the nut well. Note
that the nut has a left-hand thread.
Check the connections for leaks using a soap and
water solution.
Every time a newly filled gas bottle is connected, a
new rubber washer must be fitted. In most cases,
your gas supplier will include it with the bottle.
Keep the knob pressed-in for approximately 10
seconds, the flames will now stay burning.
• Check through the looking hole if the burner
burns completely.
EN
7