Inhaltsverzeichnis
Werbung
Emergency Stop Button and Horn
34
!
Machine In Use
36
38
www.numatic.co.uk
Machine Operation
The TTV 678 is equipped with an electronic braking system.
Simply lift your foot from the accelerator and the machine will stop.
In an emergency, strike the emergency-stop isolator button
The machine will be disabled.
To reset, turn the isolator button clockwise (see Fig.34).
After resetting the emergency stop button, to restart the
machine, turn the ignition key to the off then the on
position again.
The horn is located on the right-hand side of the operator
control panel (see Fig.35).
ALWAYS ENSURE THAT THE FLOOR IS PRE-SWEPT
AND RELEVANT SAFETY SIGNS ARE DISPLAYED
To operate, select forward or reverse, press the accelerator pedal.
Vacuum pick-up, water-flow and chemical-dose will turn on
automatically and the machine will move forward.
The clean-water / chemical mix is dispersed evenly via 'THRU- FEED'
scrubbing brushes.
The waste-water is then retrieved by the suction floor-tool (see Fig.36).
Overlap each scrubbing path by 10cm to ensure an even clean.
Do not operate the machine on inclines that exceed 11%.
On heavily soiled floors use a 'double scrub' technique.
First pre-scrub the floor with the floor-tool in the raised position,
allow the chemical time to work then scrub the area a second time
with the floor-tool lowered.
If streaking occurs wipe floor-tool blades clean.
Note: Care must be taken to reduce speed when
cornering or when manoeuvring around obstacles..
35
!
Werbung
Inhaltsverzeichnis
