Inhaltsverzeichnis
Werbung
!
ALWAYS ENSURE THAT THE MACHINE IS ON LEVEL GROUND BEFORE
DISENGAGING BRAKE ARM. NEVER DISENGAGE THE BRAKE WHEN
THE MACHINE IS ON A SLOPE / GRADIENT. NEVER TOW THE MACHINE WITH THE
BRAKE ENGAGED AND POWER PLUG CONNECTED! REMOVE BATTERY FUSES
41
The TTV 678 is equipped with a free-wheel
function that will enable the operator to move /
tow the machine. The motor brake is disengaged
by opening the brake arm on the side of the drive
wheel (see Fig.41).
43
Once the key has been inserted (see Fig.43)
the motor brake will be fully disengaged.
The machine will now be in full free-wheel mode.
45
Pull the power connector block apart and refit the
two retaining knobs.
When destination place reached, remove brake
disengage key, connect power plug, fit fusses
WHEN THE BRAKE IS DISENGAGED AND POWER PLUG IS DISCONNECTED THE MACHINE IS IN
!
FREE-WHEEL MODE AND HAS NO BRAKE FACILITY, WHEN TOWING THE MACHINE
Remember to remove the brake disengage key when you reach your final destination / before using the machine.
NOT FOLLOWING DESCRIBED METHOD COULD DAMAGE MAIN CONTROL UNIT AND VOID THE WARRANTY
48
www.numatic.co.uk
Free-wheel Function & Towing
WARNING!
ENSURE THAT A SUITABLE TOW BAR IS USED.
42
Your start-up kit includes a brake drive disengage
key (329945, see Fig.42) which can be inserted
between the brake arm and drive housing
(see Fig.43).
44
A
Undo and remove the two retaining knobs (fig.A&B).
46
When towing the machine ensure that a suitable
tow bar is used.
Care must be taken when towing; WHEN TOWING
DO NOT EXCEED AVERAGE SPEED OF 3 KPH.
The machine can be towed from the front bar as
indicated (see Fig.46).
!
B
!
Werbung
Inhaltsverzeichnis
