Inhaltsverzeichnis
Werbung
!
Always ensure that chemical manufacturer's safety guidelines are followed.
!
Do not operate machine unless the Operator Manual has been read and fully understood.
The TTV 678 ride-on scrubber dryer has an optional automatic chemical-dosing system.
Simply fill the 5 litre chemical dosing bottle and the machine will deliver the correct mix ratio as set by the operator,
depending on the floor and cleaning conditions. (See page 34)
25
To fill the chemical dosing bottle, first lift up the waste-water tank (Fig.25), remove the dosing bottle, unscrew the bottle
cap (Fig.26) and fill with appropriate cleaning chemical. Replace bottle cap, refit dosing bottle (Fig.27) and carefully lower
waste-water tank.
After use, ensure the chemical dosing tank is emptied, cleaned and refilled with clean water.
The dosing pipes also need to be cleaned and flushed through with clean-water for at least 60 seconds.
The machine is now ready to be driven to the cleaning site.
Before performing the cleaning operation, place out appropriate warning signs and sweep or dust-mop the floor.
30
www.numatic.co.uk
Chemical dosing system
WHEN HANDLING AND MIXING CHEMICALS
Only use chemicals recommended for use in auto scrubber-dryers.
Note: always ensure that the waste-water tank is empty before lifting.
IMPORTANT
26
!
!
27
Werbung
Inhaltsverzeichnis
