Unpacking And Positioning; Pre-Installation Requirements - Pkm IN4-SH Bedienungsanleitung

WARNING! The safety distance between the induction hob and a wall
cupboard above should be at least 760 mm.
WARNING! The safety distance between the induction hob and an
extractor hood above should be at least 760 mm.
CAUTION! Do not install the appliance above cooling equipment, dish
washers or laundry dryers.
CAUTION! When installing the appliance ensure optimal heat
radiation to maintain the operating safety.
CAUTION! The wall and the reach of the heat radiation above the
worktop must be made of heat-resistant materials.
CAUTION! To avoid any damage, the sandwich layer and adhesive
must resist heat.
The customer is responsible for the installation. If the manufacturer´s help is
needed to repair any damage due to improper installation, this repair work is not
covered by the guarantee. Improper installation may cause serious personal
injuries and/or property damage. The manufacturer cannot be held liable for such
injuries or damages.

Unpacking and positioning

1. Unpack the appliance carefully. Dispose of the packaging as described in chapter
WASTE MANAGEMENT
2. The appliance may be equipped with a transport-protection. Be very careful and
do not use any aggressive or abrasive detergents to remove residuals of the
transport-protection.
3. Check that the appliance and the power cord are not damaged.
4. Install the appliance in a dry and well-ventilated place.
5. Connect the appliance to a dedicated socket only.
6. Do not install the appliance in a place where it may come in contact with water
or rain; otherwise, the insulation of the electrical system will be damaged.
7. Connect the appliance to the mains properly.

Pre-installation requirements

The installation of the induction hob must meet the safety
requirements as well as the legal rules and regulations.
.
~ ~
59