Electrolux DMSL8350UO Benutzerinformation Seite 20

FlexiBridge Big Bridge mode
To activate the mode press
the correct mode indicator
connects the three rear sections into one
cooking area. The front section is not
connected and operates as a separate
cooking zone. You can set the heat setting for
each area separately. Use the two control
bars on the left side.
Correct cookware position:
Make sure to place the cookware on the three
connected sections. If you use cookware
smaller than two sections the control bar
blinks and after 2 minutes the zone
deactivates.
20 ENGLISH
until you see
. This mode
Incorrect cookware position:
FlexiBridge Max Bridge mode
To activate the mode press
the correct mode indicator
connects all sections into one cooking area.
To set the heat setting use any of the two
control bars on the left side.
Correct cookware position:
Make sure to place the cookware on the four
connected sections. If you use cookware
smaller than three sections the control bar
blinks and after 2 minutes the zone switches
off.
Incorrect cookware position:
until you see
. This mode