Electrolux DMSL8350UO Benutzerinformation Seite 15

• Wait until the display stops flashing or
reduce the heat setting of the cooking
zone selected last. The cooking zones will
continue operating with the reduced heat
setting. Change the heat settings of the
cooking zones manually, if necessary.
• The hood extractor is always available as
an electrical load.
Refer to the illustration for possible
combinations in which power can be
distributed among the cooking zones.
5.9 Hood functions
WARNING!
Refer to Safety chapters.
Activating and deactivating the hood
The hood can operate alongside the hob
during the cooking session, as well as while
the hob is switched off.
1. Press one of the fan speed levels (1-3) on
the hood control bar to activate the hood.
A signal sounds and indicators above the
hood control bar appear.
2. Adjust the fan speed setting as needed
by pressing either of the available levels
on the hood control bar.
3. To deactivate the hood, press 0 on the
hood control bar.
The indicators above the hood control bar
disappear.
AUTO
The function automatically adjusts the fan
speed level based on the selected heat
setting level of the hob.
When you use the hob for the first time, the
function is usually activated by default.
You can activate the function while the hob is
on and none of the cooking zones are active,
or at any point during the cooking session.
If you activate the function while the hob
is off, none of the cooking zones operate
and there is no residual heat visible on
the control panel, the function will switch
off by itself after a few seconds.
1. Press and hold
2. Press AUTO to activate the function.
A signal sounds and an indicator above the
symbol appears.
3. Place cookware on the hob and select a
heat setting level. Increase or decrease
the heat setting level as needed.
The hood will react to the heat setting level,
increasing or decreasing the fan speed level
accordingly. The indicators above the hood
control bar appear.
4. Press 0 on the hob control bar to
deactivate a cooking zone or
deactivate the hob.
If the residual heat indicator appears, AUTO
will continue to adjust the fan speed. If the
remaining heat is low, Breeze might start
operating as well.
5. To deactivate the function during cooking
and switch to the manual mode of the
hood, press AUTO or any other setting on
the hood control bar.
A signal sounds and the indicator above the
symbol disappears.
to activate the hob.
to
ENGLISH 15