Benning Tritest easy Bedienungsanleitung Seite 10

OperatingManualforTRITEST
Non-ContactPhase/PhaseSequenceTester
Before using the TRITEST
absolutely observe the safety instructions!
1. Safetyinstructions
- Check the phase/phase sequence tester for correct functioning immediately before and after using
it (see chapter 3)! Do not use the tester, if one or more indications are not working or if it does not
seem to be ready for operation!
- During the tests, touch the tester at the red handle behind the grip limit
the white probe tip
- The tester must be used only within the stated nominal voltage range from 200 to 1,000 V AC and
in earthed mains supply circuits of overvoltage category CAT III 1,000 V or CAT IV 600 V for phase-
to-earth measurements.
- The TRITEST
®
voltages from approx. 200 V alternating voltage (AC) on. Direct voltage (DC) fields will not be
detected!
- Please observe that work on live parts and electrical components of all kinds is dangerous! Even
low voltages of 30 V AC and 60 V DC may be dangerous to human life!
- The TRITEST
®
such as e.g. the DUSPOL
- The following factors might affect the correct functioning of the phase test and phase sequence
test:
- excessive distance to the phase (external conductor) to be tested
- excessive insulation and shielding of the phase (external conductor)
- protective clothing and insulating conditions on site
- constructional differences of sockets / CEE couplings with recessed contacts, e.g. 63 A CEE
coupling
- mains failures or lacking mains quality
- battery condition
- Do not operate the device with the battery compartment being open.
- The tester is designed for being used by qualified electricians and under safe working conditions.
- The tester must be protected against contamination and damaging of the housing surface.
Electrical symbols on the device:
Symbol Meaning
Attention! Please observe documentation!

This symbol indicates that the information provided in the operating manual must be
complied with in order to avoid risks.
This symbol on the TRITEST
insulation (protection class II).
AC
Alternating voltage
03/ 2023
easy phase/phase sequence tester: Please read the operating manual and
®
1 !
easy phase/phase sequence tester detects fields of phase/external conductor
easy phase/phase sequence tester is not a substitute for a two-pole voltage tester
to determine the absence of voltage.
®

easy indicates that the tester is equipped with protective
®
TRITEST
easy
®
easy
®
2 only and do not touch
10