Benning Tritest easy Bedienungsanleitung Seite 11


Earth (voltage to earth)
This symbol shows the orientation of the batteries for inserting them with correct polarity.
2. Devicedescription(figureA)
ProbetipwithLEDindication (green/red)
1
Grip limit
2
 LED(yellow) for activated phase/external conductor test
3
LED(red/green) for activated phase sequence test
4
ON/OFFpush-button (blue)
5
6 Clip
7 Batterycompartmentcover
3. Functional test
- Check the phase/phase sequence tester for correct functioning immediately before and after using
it!
- Press and hold the blue push-button
(green/red) of the probe tip
light up briefly).
- Test the phase/phase sequence tester for correct functioning with a familiar voltage source, e.g. a
230 V socket/5-pin CEE socket.
- Replace the batteries, if the tester switches off directly after being switched on or if the LEDs
and as well as the acoustic signal are getting weak.
4
- Do not use the TRITEST
The TRITEST
®
An acoustic signal confirms that the tester has switched off. Alternatively, press and hold the blue
push-button
5
4. Howthetesterworks
- The TRITEST
®
external conductor voltages from 200 V to 1,000 V AC (45 to 65 Hz) on.
- If an electric field is detected, the probe tip
ted. The flashing frequency of the red probe tip
increase with the electric field or the voltage applied increasing as well.
- The TRITEST
®
conductor) of an AC voltage as well as the phase sequence of a three-phase mains.
- The test does not require any current flow and no electrically conductive contact with the system
part, socket or insulated line.
- Please observe that the TRITEST
external conductor voltage from 200 V AC on.
If the TRITEST easy phase/phase sequence tester does not react, the distance to the live system part
®
might be too large, the system part might be shielded or the insulation might be too thick.
5. Phase/externalconductortestofanACvoltage (figure B)
- Press and hold the blue push-button
- The yellow LED
- Place the probe tip
- If the phase (external conductor) has been detected, this is confirmed by an acoustic signal and by
03/ 2023
1 , the yellow LED
easy, if not all functions are working properly!
®
easy is switched off automatically after approx. 5 minutes (APO, Auto-Power-Off).
to switch the TRITEST
easy phase/phase sequence tester detects electric fields generated by phase/
easy phase/phase sequence tester can be used to determine the phase (external
®
3 flashes to show that the tester is ready for operation.
1 onto the assumed phase (external conductor) of the system part.

5 to switch the tester on. The buzzer sounds and the LEDs
3 and the red LED
easy off.
®
1 lights up in red color and an acoustic signal is emit-
1 as well as the frequency of the acoustic signal
easy only responds to sufficiently strong fields with a phase/
5 to switch the tester on.
TRITEST
easy
®
4 must be functioning (must
3
11