Instruction Manual - Makita AN635H Betriebsanleitung

ENGLISH (Original instructions)
SPECIFICATIONS
Model:
Air pressure
Nail length
Nail capacity
Minimum hose diameter
Pneumatic tool oil
Dimensions (L x W x H)
Net weight
• Due to our continuing program of research and development, the specifications herein are subject to change
without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Symbols
The following show the symbols used for the equip-
ment. Be sure that you understand their meaning before
use.
Read instruction manual.
Wear safety glasses.
Do not use on scaffoldings, ladders.
Intended use
The tool is intended for the preliminary interior work
such as fixing floor joists or common rafters and framing
work in 2" x 4" housing.
Noise
The typical A-weighted noise level determined accord-
ing to EN792:
Model AN634H
Sound pressure level (L
Sound power level (L ) : 96 dB (A)
WA
Uncertainty (K) : 3 dB(A)
Model AN635H
Sound pressure level (L
Sound power level (L ) : 96 dB (A)
WA
Uncertainty (K) : 3 dB(A)
WARNING:
Wear ear protection.
Wire-collated coil nail
Sheet-collated coil nail
Wire-collated coil nail
Sheet-collated coil nail
) : 83 dB(A)
pA
) : 83 dB(A)
pA
AN634H
1.18 - 2.26 MPa (11.8 - 22.6 bar)
ISO VG32 or equivalent
284 mm x 125 mm x 296 mm
2.1 kg
Vibration
The vibration total value determined according to
EN792:
Model AN634H
Vibration emission (a
Uncertainty (K) : 1.5 m/s
Model AN635H
Vibration emission (a
Uncertainty (K) : 1.5 m/s
NOTE: The declared vibration emission value has
been measured in accordance with the standard test
method and may be used for comparing one tool with
another.
NOTE: The declared vibration emission value
may also be used in a preliminary assessment of
exposure.
WARNING:
The vibration emission during actual
use of the power tool can differ from the declared
emission value depending on the ways in which the
tool is used.
WARNING:
Be sure to identify safety measures
to protect the operator that are based on an estima-
tion of exposure in the actual conditions of use (taking
account of all parts of the operating cycle such as
the times when the tool is switched off and when it is
running idle in addition to the trigger time).
EC Declaration of Conformity
For European countries only
The EC declaration of conformity is included as Annex A
to this instruction manual.
7 ENGLISH
AN635H
32 mm - 65 mm
32 mm - 65 mm
200 pcs - 400 pcs
200 pcs
4.0 mm
297 mm x 125 mm x 296 mm
2.2 kg
2
) : 4.0 m/s
h
2
2
) : 4.0 m/s
h
2