Instruction Manual - Makita LS1019 Betriebsanleitung

ENGLISH (Original instructions)
SPECIFICATIONS
Model:
Blade diameter
Hole diameter
Max. kerf thickness of the saw blade
Max. miter angle
Max. bevel angle
No load speed (RPM)
Laser type
Dimensions (L x W x H)
Net weight
Cutting capacities (H x W)
45° (right and left)
60° (right and left)
Cutting capacities for special cuttings
Type of cutting
Crown molding 45° type
(with crown molding stopper used)
Base board
(with horizontal vise used)
• Due to our continuing program of research and development, the specifications herein are subject to change
without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2014
Symbols
The following show the symbols used for the equip-
ment. Be sure that you understand their meaning before
use.
Read instruction manual.
DOUBLE INSULATION
To avoid injury from flying debris, keep
holding the saw head down, after making
cuts, until the blade has come to a com-
plete stop.
European countries
Countries other than Europe
European countries
Countries other than Europe
Miter angle
0°
LS1019
-
805 mm x 644 mm x 660 mm
26.1 kg
45° (left)
42 mm x 310 mm
58 mm x 279mm
42 mm x 218 mm
58 mm x 197 mm
-
14 ENGLISH
LS1019L
260 mm
255 mm - 260 mm
30 mm
25.4 mm
3.2 mm
Right 60°, Left 60°
Right 48°, Left 48°
-1
3,200 min
Red Laser 650 nm, Maximum
output
( Laser Class 2M )
26.3 kg
Bevel angle
0°
68 mm x 310 mm 29 mm x 310 mm
91 mm x 279 mm 43 mm x 279 mm
68 mm x 218 mm 29 mm x 218 mm
91 mm x 197 mm 43 mm x 197 mm
68 mm x 155 mm
91 mm x 139 mm
Cutting capacity
168 mm
133 mm
When performing slide cut, first pull car-
riage fully and press down handle, then
push carriage toward the guide fence.
Do not place hand or fingers close to the
blade.
Never look into the laser beam. Direct laser
beam may injure your eyes.
Only for EU countries
Do not dispose of electric equipment
together with household waste material! In
observance of the European Directive, on
Waste Electric and Electronic Equipment
and its implementation in accordance with
national law, electric equipment that have
reached the end of their life must be col-
lected separately and returned to an envi-
ronmentally compatible recycling facility.
1.6mW
45° (right)
-