Cleaning The Hot Water Shower; Cleaning The Accessories - Silvercrest SEM 1100 D3 Bedienungsanleitung

6) Wipe the nozzle under the casing with a damp cloth . If necessary, add a little
mild detergent onto the cloth . After cleaning with detergent, always wipe off
with a cloth moistened with clean water . Ensure that there is no detergent
residue left on the nozzle .
7) Push the casing back onto the nozzle (Figure 3) .

Cleaning the hot water shower

Clean the hot water shower r after each use:
1) After you have prepared the espresso/cappuccino and removed the sieve
holder i, wipe the entire surface of the hot water shower r with a mois-
tened cloth to remove all powder residues .
2) Replace the sieve holder i without the espresso filters o p .
3) Place an empty cup under the portafilter i and press the "Espresso" button
3 . Water flows out of the hot water shower r rinsing out the remaining
powder residue .
4) After about 20 seconds, press the "Espresso" button
switch the appliance off with the On/Off switch 1 .
5) Remove the sieve holder i again .

Cleaning the accessories

1) Clean the sieve holder i, the two espresso sieves o p, water tank 9, the
measuring spoon a and the drip grille q in warm water .
NOTE
► If you put detergent into the water, it may effect the taste of the espresso .
If the stains can only be removed with detergent, always rinse the items
afterwards with lots of clean water .
2) Dry all parts well .
SEM 1100 D3
Figure 3
3 again and
GB │ IE │ NI │ CY │ 17 ■