Product Identification; Technical Data - Emerson AVENTICS AV Montageanleitung

1 Scope of delivery
• 1x end plate with seal and mounting screws, as ordered
• 1x set of assembly instructions

2 Product identification

Observe the product information on the product and packaging.
3 Exchanging the end plate
The product is a component. Observe the documentation information during dis-
assembly and assembly of your valve system.
Danger of injury if assembled under pressure or voltage!
Assembling when under pressure or electrical voltage can lead to injuries and
damage to the product or system components. Danger of injury from electric
shocks and sudden pressure drops.
1. Make sure the relevant system part is not under pressure or voltage before
performing the following tasks:
- Disassembling/assembling the product
- Removing or connecting plugs
- Assembling/disassembling the system
2. Protect the system against being restarted.
Damage to the valve contacts!
Removing the circuit board (2) from the VS block separates the electrical con-
tacts to the VS valves. Reinserting the circuit board (2) will result in damage to
the previously separated contacts!
1. Make sure that the circuit board (2) is not removed from the VS block dur-
ing disassembly and installation of the D-Sub port.
2. If the printed board is accidentally removed, do not slide it back into the VS
block!
- Remove all valves installed in the VS from the base plates.
- Then re-position the circuit board in the VS block.
- Remount all valves on the base plates.
AVENTICS™ AV | R412018510-BAL-001-AE | English
CAUTION
NOTICE
Exchanging the end plate with D-Sub port
SW4,5
±0,1
M = 0,5 Nm
D
3
2
1
±0,1
M = 0,95 Nm
D
6
7
8
Fig. 1: Exchanging the end plate with D-Sub port
2 Circuit board
Assembling the end plate for AV03-SW
±0,1
M = 0,95
D
1
Fig. 2: Assembling the end plate for AV03-SW
4 Disposal
Comply with national regulations regarding disposal.

5 Technical data

Further technical data can be found on the product page at the Emerson store.
2
2
4
5
SW4,5
±0,1
M = 0,5 Nm
D
Nm
3
2
3