Please Provide The Following Information In The Event Of Any Enquiries; Important Hint In Case Of Sending The Plates To A Service Station; Service Information; Disposal And Recycling - Scheppach HP1800S Original Bedienungsanleitung

• Check and set the electrode gap. To make sure that
the engine remains efficient, the spark plug (8) must
have the right electrode gap (0.7-0.8 mm).
• Manually screw the spark plug (8) in and tighten it
with the spark plug spanner (g) approximately 1/4 of
a revolution.
• Place the spark plug connector on the spark plug (8).
Cleaning the float chamber (fig. Z)
m ATTENTION! Only remove the float chamber when
the engine is cold!
1. Close the fuel valve (11).
2. Loosen the drain plug (t) on the float chamber and
drain the fuel into a suitable container.
3. Attach the drain plug (t) again
4. Loosen the fastening screw (u) of the float cham-
ber.
5. Unscrew the float chamber and radial seal and
thoroughly clean them in a non-flammable solvent
and let them dry. Check the radial seal for dents
and damage.
6. Screw both parts back on.
7. Screw on the fuel valve (11) and check it for leaks.
Please provide the following information in the
event of any enquiries:
• Machine data - type plate
• Engine data - type plate
Important hint in case of sending the plates to a
service station:
Due to security reasons please see to it that the vibra-
tory plates are sent back free of oil and gas!

Service information

Please note that the following parts of this product are
subject to normal or natural wear and that the following
parts are therefore also required for use as consum-
ables.
Wear parts*: Spark plug, oil, belt, rubber pad, air filter
* Not necessarily included in the scope of delivery!
Spare parts and accessories can be obtained from our
service centre. To do this, scan the QR code on the
cover page.

15. Disposal and recycling

Notes for packaging
You can find out how to dispose of the disused
device from your local authority or city adminis-
tration.
Fuels and oils
• Before disposing of the unit, the fuel tank and the
engine oil tank must be emptied!
• Fuel and engine oil do not belong in household
waste or drains, but must be collected or disposed
of separately!
• Empty oil and fuel tanks must be disposed of in
an environmentally friendly manner.
www.scheppach.com
The packaging materials are recy-
clable. Please dispose of packag-
ing in an environmentally friendly
manner.
GB | 35